Seymour Midwest Twist Bracing(PK90331) - Manual

Twist Brace
Assembly Instructions
Tools Needed for Assembly
- 7/16” wrench (two)
Parts Shipped with Unit:
- Head with riveted twist braces
- Bolt bag for brace
- Aluminum handle with cap (not shown)
Assembly Instructions for Handle:
1. Slide slotted end of handle over center hole on aluminum head.
2. Align holes and insert shorter bolt. Do not tighten until all
hardware is in place.
Twist Brace Instructions:
1. Rotate ends of braces out to handle. Align holes of
braces with the handle as shown, and insert the longer bolt.
2. Start both loc nuts on bolts. Use wrenches to tighten, being
careful not to over tighten. Over tightening may result in crushing
the handle, thereby compromising its strength.
Mailing Address: Shipping Address:
PO Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674 Warsaw, IN 46580
REPLACEMENT PARTS LIST
See Reverse Side
PK90331
01/21/15
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 8 44-SEYMOUR
FAX: 574-267-8508 ��
www. seymourmidwest.com