Seymour Midwest Roller Squeegee, Single Ribbed w/ Gusset Bracing(PK90332) - Manual

Roller Squeegee
Single-Ribbed Style, Gusset Bracing
Assembly Instructions
Parts Shipped with Unit:
ƒ Head assembly
ƒ Aluminum handle (not pictured)
ƒ Gusset braces (set of 2)
ƒ Bolt bag
ƒ Hook hardware bag
Tools Needed for Assembly:
ƒ 7/16” wrench (two)
ƒ 1/2” wrench
If Roller Squeegee comes without a protective cardboard tube, proceed to
Handle Instructions.
If Roller Squeegee comes with a protective cardboard tube, follow these
instructions:
1. DO NOT attempt to remove the tube by cutting.
2. On one end of roller, using a 1/2” wrench, remove the hex head bolt, loc
washer and axle.
3. Slide off cardboard tube.
4. Replace axle, loc washer, and bolt as shown. Tighten.
Assembly Instructions for Hook:
1. With label side of handle facing up, position hook as shown.
2. Insert longest bolt. Tighten nut.
Gusset Brace Instructions:
1. Slide slotted handle over the center hole on the aluminum frame.
2. Position one gusset on bottom of handle, as shown, and the other gusset
on top of the handle.
3. Insert the two longest bolts through the top gusset, the handle, and the
bottom gusset. Insert the two shortest bolts through the two remaining
holes.
4. Tighten all nuts being careful not to over tighten. Over tightening hardware
may result in crushing the handle, thereby compromising its strength.
Mailing Address: Shipping Address:
PO Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674 Warsaw, IN 46580
REPLACEMENT PARTS LIST
See Reverse Side
PK90332
01/21/15
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 8 44-SEYMOUR
FAX: 574-267-8508 ��
www. seymourmidwest.com