Seymour Midwest Chisel-Tooth Rake(PK90087) - Manual

Chisel-Tooth Rake
Assembly Instructions
Tools Needed for Assembly:
- 7/16” wrench (two)
Parts Shipped with Unit:
- Head
- Bolt bag for brace
- Wrap-around brace (set of 2)
- Aluminum handle with grip (not shown)
Assembly Instructions for Handle:
1. With rake head positioned as shown (grading edge facing forward),
insert flat-tipped end of handle into channel-shaped crossbar.
NOTE: This may be a tight fit requiring working the handle back and
forth.
2. Align holes and insert middle sized bolt. Do not tighten until all hardware
is in place.
Wrap-around Brace Instructions:
1. Align holes of flat end of braces with holes on rake head, as shown, and
insert the two shortest bolts.
2. Align holes of wrap-around end of braces with the handle, as shown, and
insert the longest bolt.
3. Start all loc nuts on bolts. Use wrenches to tighten, being careful not to
over tighten. Over tightening may result in crushing the handle, thereby
compromising its strength.
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
PK90087
1/14/15
REPLACEMENT PARTS LIST
See Reverse Side
Mailing Address: Shipping Address:
P.O. Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674
Phone: 844-SEYMOUR
Fax: 574-267-8508
www.seymourmidwest.com
Warsaw, IN 46580