Seymour Midwest Flexible Blade Smoother(PK90327) - Manual

Mailing Address: Shipping Address:
PO Box 1674
2666 S Country Club Rd
Warsaw, IN 46581-1674 Warsaw, IN 46580
Flexible Blade Smoother
Assembly Instructions
Tools Needed for Assembly:
ƒ 7/16” wrench (two)
Parts Shipped with Unit:
ƒ Head/Blade Assembly
ƒ Threaded handle adapter or aluminum handle (not pictured)
ƒ Gusset brace (set of 2) – one gusset is labeled if unit comes
with threaded handle adapter
ƒ Bolt bag for braces
Gusset Brace Instructions:
1. Slide slotted handle or threaded handle adapter over the center
hole on the aluminum frame.
2. Position labeled gusset on bottom of adapter, as shown, and the
other gusset on top of the adapter. If unit comes with handle,
gussets are interchangeable.
3. Insert the two longest bolts through the top gusset, the
handle/adapter and the bottom gusset. Insert the two shorter bolts
through the two remaining holes on the frame.
4. Tighten all nuts, being careful not to over-tighten. Over-tightening
hardware may result in crushing the handle, thereby compromising
its strength.
If blade is ever to be replaced, use 3/8” wrench and Phillips screwdriver. Call
our toll-free phone number for assistance if needed.
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
REPLACEMENT PARTS LIST
See Reverse Side PK90327
01/21/15
Phone: 844-SEYMOUR
FAX: 574-267-8508 ��
www.seymourmidwest.com