Seymour Midwest Aluminum Roller(PK90288) - Manual

Mailing Address: Shipping Address:
PO Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674
Phone: 8 44-SEYMOUR
FAX: 574-267-8508 ��
www. seymourmidwest.com Warsaw, IN 46580
Aluminum Roller
Assembly Instructions
Tools Needed for Assembly:
ƒ 7/16” wrench (two)
ƒ 1/2” wrench (one)
Parts Shipped with Unit:
ƒ Aluminum Frame
ƒ Aluminum Roller
ƒ Threaded handle adapter or aluminum handle (not pictured)
ƒ Gusset brace (set of 2) – one gusset is labeled if unit comes
with threaded handle adapter
ƒ 2 Stainless steel axles
ƒ 2 Loc washers
ƒ 2 5/8” x 5/16” bolts
ƒ Bolt bag for braces
Gusset Brace Instructions:
1. Slide slotted handle or threaded handle adapter over the center
hole on the aluminum frame as shown in second photo.
2. Position one gusset on bottom of handle/adapter, and the other
gusset on top of the handle/adapter as shown in third photo.
3. Insert the two longest bolts through the top gusset, the
handle/adapter and the bottom gusset. Insert the two shorter bolts
through the two remaining holes on the frame.
4. Tighten all nuts, using 7/16” wrenches, being careful not to over-
tighten. Over-tightening hardware may result in crushing the
handle, thereby compromising its strength.
Assembly Instructions for Roller Head:
1. Insert an axle into each end of the roller.
2. Slide the roller into the channels on the frame, as shown.
3. Place a loc washer on each of the two 5/8” x 5/16” bolts and insert
them into each end of the roller head assembly.
4. Tighten both bolts, using 1/2” wrench, being careful not to over
tighten.
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
REPLACEMENT PARTS LIST
See Reverse Side
PK90288
0 1/21/14