Seymour Midwest CAM® Gauge Rake(PK90090) - Manual

Mailing Address: Shipping Address:
PO Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674
Phone: 8 44-SEYMOUR
FAX: 574-267-8508
www.
seymourmidwest.com Warsaw, IN 46580
CAM ® Gauge Rake
Assembly Instructions
Tools Needed for Assembly:
ƒ 7/16” wrench (two)
Parts Shipped with Unit:
ƒ Head assembly
ƒ Threaded handle adapter or aluminum handle (not pictured)
ƒ Gusset brace (set of 2) – one gusset is labeled
ƒ Bolt bag for braces
CAM
® sets are ordered separately and may or may not be
shipped with this unit
Gusset Brace Instructions:
1. Slide slotted handle or threaded handle adapter over the center
hole on the aluminum frame.
2. Position labeled gusset on bottom of handle/adapter, and the other
gusset on top of the handle/adapter as shown.
3. Insert the two longest bolts through the top gusset, the
handle/adapter and the bottom gusset. Insert the two shorter bolts
through the two remaining holes on the frame.
4. Tighten all nuts, being careful not to over-tighten. Over-tightening
hardware may result in crushing the handle, thereby compromising
its strength.
CAM ® Assembly:
1. Remove the wing nut and loc washer on each end of the head
assembly.
2. Place the CAM ® on the head, as shown, followed by the loc washer.
Secure with wing nut. Do the same on the opposite end of the
head.
3. Make sure CAM ® striking surface is in line with screed edge, as
pictured.
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
REPLACEMENT PARTS LIST
See Reverse Side
PK90090
1/14/15