Seymour Midwest Maximum-Duty Broom(PK90221) - Manual

Mailing Address: Shipping Address:
PO Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674 Warsaw, IN 46580
Maximum Duty Broom
Assembly Instructions – Wrap-Around Bracing
Tools Needed for Assembly:
-7/16” wrench (two)
Parts Shipped with Unit:
-Head with bristles
-Aluminum handle with vinyl grip (not shown)
-Wrap-around braces (set of 2)
-Bolt bag
Assembly Instructions for Handle:
1. Slide slotted end of handle onto aluminum head.
2. Align holes and insert medium sized bolt. Do not tighten until all
hardware is in place.
Wrap-Around Brace Instructions:
1. Align holes of wrap-around end of braces with the handle and insert
the longest bolt.
2. Align holes of flat end of braces with holes on head assembly, as
shown, and insert the two shortest bolts.
3. Start all loc nuts on bolts. Use wrenches to tighten, being careful
not to over-tighten. Over-tightening may result in crushing the
handle, thereby compromising its strength.
REPLACEMENT PARTS LIST
See Reverse Side PK90221
01/21/15
Assembly Instructions for Brush Replacement:
1. On one end of broom head, remove the two screws
and end cap.
2. Holding broom securely, pull out each row of bristles.
NOTE: This may require some effort, as bristles
are tight.
3. Make sure bristle channel(s) are clean.
4. Slide replacement bristle(s) into channel. Light
tapping with a hammer may be required.
5. Replace end caps and screws.
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 8 44-SEYMOUR
FAX: 574-267-8508 ��
www. seymourmidwest.com