Seymour Midwest Smoother(PK90283) User Manual
Smoother, Assembly instructions, Replacement parts list
Mailing Address:
Shipping Address:
PO Box 1674
2666 S Country Club Rd
Warsaw, IN 46581-1674
Warsaw, IN 46580
Smoother
Assembly Instructions
Tools Needed for Assembly:
7/16” wrench (two)
Parts Shipped with Unit:
Head/Blade
Assembly
Threaded handle adapter or aluminum handle (not pictured)
Gusset brace (set of 2) – one gusset is labeled if unit comes
with threaded handle adapter
Bolt bag for braces
Gusset Brace Instructions:
1. Slide slotted handle or threaded handle adapter over the center
hole on the aluminum frame.
2. Position labeled gusset on bottom of adapter, as shown, and the
other gusset on top of the adapter. If unit comes with handle,
gussets are interchangeable.
3. Insert the two longest bolts through the top gusset, the
handle/adapter and the bottom gusset. Insert the two shorter bolts
through the two remaining holes on the frame.
4. Tighten all nuts, being careful not to over-tighten. Over-tightening
hardware may result in crushing the handle, thereby compromising
its strength.
Smoother Blade Replacement Instructions:
1. Remove nuts on head, lift head off bolts, and remove used blade.
2. Replace o-rings on bolts if necessary.
3. Fit new blade onto bolts.
4. Fit head onto bolts.
5. Tighten nuts until head assembly is secure, being careful not to
over-tighten.
REPLACEMENT PARTS LIST
See Reverse Side
PK90283
01/21/15
FULL WARRANTY
All
Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 8
44-SEYMOUR
FAX: 574-267-8508
��
www.
seymourmidwest.com