Seymour Midwest Thin Coat Applicator(PK90202) - Manual

Thin Coat Applicator
Assembly Instructions
Gusset Brace Instructions:
1. Slide slotted handle or threaded handle adapter over the center hole on the
aluminum frame.
2. Position labeled gusset on bottom of adapter, as shown, and the other gusset
on top of the adapter. If unit comes with handle, gussets are interchangeable.
3. Insert the two longest bolts through the top gusset, the handle/adapter, and
the bottom gusset. Insert the two shortest bolts through the two remaining
holes.
4. Tighten all nuts being careful not to over tighten. Over tightening hardware
may result in crushing the handle, thereby compromising its strength.
PK90202
01/21/15
Parts Shipped with Unit:
-Head
-Threaded handle adapter or aluminum handle (not pictured)
-Gusset brace (set of 2 – one is labeled if unit comes with adapter)
-Bolt bag for brace
-Solvent resistant nylon blade
Nylon Blade Installation Instructions:
1. Loosen nuts (do not remove) on head and insert nylon blade. Shorter edge
fits into head.
2. Rest nylon blade on a hard, flat surface and adjust blade to ensure it is
seated straight in the head and level with the flat surface.
3. Tighten nuts until nylon blade is secure, being careful not to over tighten.
NOTE: It is important when installing or replacing the nylon blade that it be
installed straight.
Mailing Address: Shipping Address:
P.O. Box 1674 2666 S Country Club Rd
Warsaw, IN 46581-1674 Warsaw, IN 46580
REPLACEMENT PARTS LIST
See Reverse Side
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 8 44-SEYMOUR
FAX: 574-267-8508 ��
www. seymourmidwest.com