Panasonic Panafax UF-766 - Manual (Page 95)

SPECIALIZED FEATURES
Setting Up Your Machine for Relayed Transmission
To set up your machine for relayed transmission, use the procedures on the following pages to set the eight parameters
listed below. Some parameters (e.g., relayed XMT fax parameter) are only set once, but others must be set separately for
each station in the relay network.
Relayed XMT Fax Parameter
This switches the relayed XMT function to ON or OFF.
Own Telephone Number
Your full telephone number should be entered.
Network Address
End receiving station telephone numbers set in an initial
sending station may be different from the numbers set
at the relay station. To send a fax to an end receiving
station via the relay station, each station in the network
must be identified with a certain code that does not vary
depending on where you call from. The code is the
network address, which consists of a four-digit number
and is assigned to a One-Touch/Abbreviated number.
Network Password
The network password is a four-digit number that
prevents unauthorized (outside) stations from accessing
the relay station and using its memory. Every station in
the network should set the same network password.
One'Touch/Abbreviated Numbers
The One-Touch or Abbreviated number you set must
represent the fax number of a particular station in the
network as seen from your station.
Relay Station Parameter (Yes/No)
Set "Yes" if the particular station you are recording is a
relay station. If you are connected to more than one relay
station in series, set "Yes" only for the first relay station.
Relay Address
The relay address is a two-digit number that identifies
the relay station your machine will use. Your machine
may be connected to more than one relay station in
parallel, but when you use relayed XMT your machine
will only send documents to the relay station identified
by the relay address.
One*Station XMT (Relay/Direct) Parameter
If you send a document to only one end receiving station,
you can set your machine to transmit directly to that
station without going through the relay station by
selecting "Direct." Set "Relay" if you always want to go
through the relay station.
88