Yamaha FX550 - Manual (Page 33)

Chapter 5: Remote Control
Bypass
You can select which effect sections are bypassed using the foot switch.
• Set Up Procedure
1. Press the [ ▼ ] or [ A ] button to select the program to be controlled.
2. Press the [EDIT] button to show the FOOT ON/OFF display.
3-1. To bypass all effect sections:
Press the [ -^ ] or [ ► ] button to position the cursor, and select “BYPASS : Used” using
the [ ▼ ] or [
A ] button.
3-2. To set individual effect sections for bypass:
© Press the [ -^ ] or [ ► ] button to position the cursor, and select “BYPASS : Unused”
using the [ T ] or [ A ] button.
@ Press the [ -^ ] or [ ► ] button to position the cursor, and use the [ ▼ ] or [ A ] button
to select COMP.
@ Press the [ -^ ] or [ ► ] button to position the cursor, and use the [ T ] or [ A ] button
to select “Used” if you wish to be able to bypass the COMP section using the foot
switch, or “Unused” if you do not.
0 Repeat the above steps @ and 0 for each effect section: DIST, EQ, MOD and REV.
4. Store the settings and switch to Play mode.
• Operation Procedure
1. Connect the foot switeh to the BYPASS jack on the rear panel.
2. Play the guitar, and press the foot switch when you want to bypass the effect sections speci­
fied in the above “Set Up Procedure”. The specified effects will be bypassed and the corre­
sponding indicators will show bypassing.
3. Press the pedal again to un-bypass. The corresponding indicators will light up again.
31