Yamaha FX550 - Manual (Page 14)

Chapter 3: Editing, storing, and titling an effect program
4. Edit Step 2
© Press the [COMP], [DIST], [EQ], [MOD], or [REV] button to select the effect button sec­
tion that you want to edit. The display below shows some of the [COMP] effect section’s
parameters.
/ ;i:
Pressing the respective section button again will show the next group of parameters.
@ Use the [ -4 ] and [ ^ ] buttons to select parameter that you want to edit.
Use the [ ▼ ] and [ ▲ ] buttons to set the parameter value.
Effect parameters are explained in detail in Chapter 4.
Adjusting parameters
To decrease a parameter value quickly, press and hold down [^ ], then press [A. ].
To increase a parameter value quickly, press and hold down [ A ] , then press [T ].
I®” Bypassing an effect while editing
It is better to adjust parameters while producing a sound. However, when you want to com­
pare the affected sound with the dry sound, press the [BYPASS] button to temporarily bypass
the effect section. Press the [BYPASS] button again to un-bypass the effect section.
While you are editing an effect section, the corresponding indicator will flash. When you
bypass the effect section, the corresponding indicator will also flash, however, the flashing
time will be shortened.
12