Notes, Lens drive signal selection (lens drive) – Panasonic WV-CPR650 User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Notes:
• Masking or adjusting the detection level is needed
to prevent malfunction under the following condi*
tions;
• When shooting an object under flickering fluores
cent light or shooting in ELC,
• When leaves or curtains etc. are swayed by the
wind.
• When the object is lighted by lighting equipment
that constantly turns on and off.
9. Lens Drive Signal Selection (LENS
DRIVE)
This item is used to select the type of auto iris lens
drive signal to be supplied to the lens from the auto iris
lens connector.
** CAM
1
SET OP * *
CAMERA ID
OFF n
ADC/EDC
ADC
SHUTTER
—
AGC
ON
SENS DP
OFF
SYNC
INT
WHITE HAL
ATW n
MOTION DET
OFF *1
I£NS DRIVE
PGi
1. Move the cursor to the LENS DRIVE parameter.
2. Select DC if you are using the auto iris lens that
requires a DC drive signal.
Select VIDEO if you are using the auto iris lens that
requires a video drive signal.
-37-