Panasonic WV-CPR650 - Manual (Page 36)

• To reset COARSE and FINE to the values pre­
set at the factory, press ^ or simultane­
ously. COARSE and FINE adjustments are
preset at the factory to zero-crossing of the
AC line phase.
• If the AC line contains noise (spike noise,
etc.), the stability of the vertical phase of the
camera video output signal may be disturbed.
7. White Balance Setting (WHITE BAL)
7>1. Auto-Tracing White Balance Mode (ATW)
You can select one of two modes for white balance
adjustment as follows:
• ATW (Auto Tracing White Baiance)
In this mode, the color temperature is monitored
continuously and thereby white balance is set auto­
matically. The color temperature range for the prop­
er white balance is approximately 2 600 - 6 OOOK.
Proper white balance may not be obtained under
the following conditions:
1. The color temperature is out of the 2 600 -
6 OOOK range.
2. When the scene contains mostly high color
temperature objects, such as a blue sky or
sunset.
3. When the scene is dim.
In these cases, select the AWC mode.
Move the cursor to the WHITE BAL parameter and
select ATW. The white balance of the camera is
automatically set.
/----------
** CAM SET DP **
CAMERA ID OFF
ALC/ELC ALC ~l
SUUTTER —
AOC ON
SEMS OP OFF
SYMC IWT
WHITE BAL ATW; 1
MOTION DET OFF 1
LENS DRIVE DC
RET
Ч__________ У
Automatic White Baiance Controi Mode (AWC)
In this mode, accurate white balance is obtained
within a color temperature range of approximately
2 300-10000K.
Move the cursor to the WHITE BAL parameter and
select AWC PUSH SW.
—
** CAM SET OP * «
CAMERA ID OFF n
ALC/ELC ALC n
SHUTTER —
лес ON
SENS OP OFF
SYNC INT
WHITE BAL AWC^PUSBISW
MOTION DET OFF 1
LENS DRIVE DC
RET
>
-34-