Panasonic WV-CPR650 - Manual (Page 23)

S
etting procedures
• RS485 Set Up
You can remote control this camera by using a speci­
fied extension unit such as computer with a modem.
The RS485 menu is used to set the parameters of the
items for RS485 site communication below.
Move the cursor to RS485 of the SET UP menu and
press El. The RS4S5 menu appears on the monitor
screen.
Illustration of RS 485 menu
UNIT NUMBER
This item is used to select the camera number that is
used with RS485 communication.
1. Move the cursor to the parameter of UNIT NUM­
BER.
2. Select the camera number to be used with RS485
communication and press .
BAUD RATE
This item is used to select the transmission speed tor
the RS485 communication. (BAUD is the unit of bit per
second.)
1. Move the cursor to the parameter of BAUD RATE.
2. Select the transmission speed and press El.
DATA BIT
This item is used to select the data bits for the RS485
communication.
1. Move the cursor to the DATA BIT parameter.
2. Select the data bits and press EH.
PARITY CHECK
This item is used to select the parity for the RS485
communication.
1. Move the cursor to the PARITY CHECK parameter.
2, Select the parity and press O ■
STOP BIT
This item is used to select the stop bit for the RS485
communication.
1. Move the cursor to the STOP BIT parameter.
2. Select the stop bits and press El.
X ON/X OFF
This item is used to select applying the flow control or
not.
1. Move the cursor to the X ON/X OFF parameter.
2. Select NOT USE (not apply flow control) or USE
(apply flow control) and press El ■
-21-