Panasonic WV-CPR650 - Manual (Page 34)

6-2. VS Gen-lock Mode (EXT(VS))
1. Move the cursor to the SYNC parameter and
select INT.
2. Connect the coaxial cable for the composite sync
or composite BM video signal to the gen-lock
input connector.
3. Confirm that the parameter INT changed to EXT
(VS) on the menu.
Caution: The gen-lock input signal should meet
with EIA RS-170 specifications and should not
contain jitter, such as a VCR playback signal ,
as it could disturb synchronization.
X------------ —^ r
** CAM SET UP • * •• CAM SET UP **
СЛМЕЯЛ ID OFF “1 CAMERA ID OFF 1
АЬС/ЕЬС ALC A1 ALC 1
SHUTTER — SHUTTER - - -
лес ON L AGC ON
SENS UP OFF
4
SENS UP OFF
SYNC ^XOT. SYNC EXT (VS)
WHITE BAl. ATW “1 WHITE HAL ATW
MOTION OBT OFF MOTION DBT OFF ~]
LENS DRIVE DC lens drive DC
^ RET ^ RET
>
After confirming the cursor is on EXT (VS), press
El ■ The phase adjustment menu appears on the
monitor.
f ---- Ч
* * SYNC •*
В PHASE
RET END
V________ J
5. Move the cursor to H PHASE. The cursor starts
blinking.
6. Supply the video output signal of the camera to be
adjusted and the reference gen-tock input signal
to a dual-trace oscilloscope.
7. Set the oscilloscope to the horizontal rate and
expand the horizontal sync portion on the oscillo­
scope.
8. Adjust the horizontal phase by pressing €1 or
. The adjustable range is 0 - 2.Ops.
6-3. Line-lock Sync Mode (LL)
Note: The line-lock (LL) sync mode is not available
when the camera operates on DC power.
1. Move the cursor to the SYNC parameter and
select LL.
Note: The settings in this menu can be made only
when the multiplexed vertical drive signal
(VD2) is not supplied to the camera.
-32-