Panasonic WV-CPR650 - Manual (Page 20)

2. SETUP OPERATION
This camera utilizes a user setup menu (SET UP) that is
displayed on the monitor.
To set items on the CAM SET UP and RS485 menu,
use the following buttons on the side panel.
■up Button
Left Button--------Ccn I------------ 0
Set Switch
—Right Button
■ Down Button
Up Button
Down Button ):
Right Button ( ):
This button is used to move the
cursor upwards. Use this button to
select an item or adjust the para­
meters.
This button is used to move the
cursor downwards. Use this but­
ton to select an item or adjust the
parameters.
This button is used to move the
cursor to the right. Use this button
to select or adjust the parameters
of the selected item. The parame-
Left Button );
Set Button ( E l ) :
ter changes each time this button
is pressed.
This button is used to move the
cursor to the left. Use this button
to select or adjust the parameters
of the selected item. The parame­
ter changes each time this button
is pressed.
This button is used to set the
determined parameter. If the item
has its own setting menu ( T indi­
cates that the setting menu
exists), press this button to dis­
play the setting menu.
• All Reset Operation
All Reset allows you to reset all setup menu items to
the factory settings if you are unsure about the correct
settings. Proceed as follows:
(1) Make sure that the SET UP menu is not displayed
(a camera picture is displayed),
(2) While pressing both ^ and , press El for a
few seconds. The words ALL RESET momentarily
appear on the monitor.
At this time all adjustments and parameters are
reset to the factory default settings.
-18-