Panasonic WV-CPR650 - Manual (Page 29)

4. Repeat step 1 to 3 to mask the desired area. To
cancel masking, move the cursor to that area and
press cm.
After masking is completed, press EJ for 2 sec­
onds or longer. The ALC CONT menu appears.
If you want to change the video output level (pic­
ture contrast), move the "I" cursor for LEVEL and
adjust the level.
Move the cursor to RET and press E] to return to
the CAM SET UP menu, (To return to the camera
picture, move the cursor to END and press the set
button.)
Note: When ON is selected for SUPER-D on the ALC
CONT menu, this item is not available.
To select electronic shutter speed, select OFF for
SUPER-D in the menu.
You can select an electronic shutter speed of 1/60
(OFF), 1/100, 1/250. 1/500, 1/1 000, 1/2 000, 1/4 000,
or 1/10 000 seconds.
This function is effective to raise the sensitivity in low
light conditions when OFF is selected for ALC.
3. Shutter Speed Setting (SHUTTER)
•* CAM SET UP * *
CAMERA ID OFF
ADC/ELC ALC
SHUTTER
AGC OH
SE3IS UP OFF
SYNC 1ЫТ
WHITE BAI. ATW
MOTION DET OFF
LENS DRIVE DC
Move the cursor to the SHUTTER parameter and seleot
the electronic shutter speed.
The preset values for SHUTTER (electronic shutter
speed) change by pressing ^ or as follows;
p—OFF(1/60) —1/100 — 1/250 I
—1/10000—1/4000 — 1/2000-
- 1/500
1/1000
-27-