Panasonic WV-CPR650 - Manual (Page 38)

The motion deteotor detects the moving objects in the
scene by monitoring the brightness level changes. You
can select the level of sensitivity for motion detection.
Note: The alarm signal is supplied only v/hen RS485
communication is used.
1. Move the cursor to the MOTION DET parameter
and select ON.
2. Press O. The MOTION DETECT menu appears
on the monitor screen.
8. Motion Detector Setting (MOTION DET)
/----------
** CAM SET UP ••
CAMERA ID 07F 1
AIiC/ELC ADC n
SHUTTER - - -
AGC ON
SENS OP Q V y
SYNC INT
WHITE BAD AWC n
MOTION DET k»i3 1
DENS DRIVE DC
RET
__ >
3. Move the cursor to MASK SET and press [i]. The
MASK SET menu has 48 masks. To set MASK SET,
proceed as described in steps 2 to 4 of "ALC
mode with SUPER-D OFF and ELC mode” on page
26.
4. Move the cursor to the ALARM parameter and
select ON or OFF to set the alarm in the DISPLAY
MODE.
Note: When the system controller WV-RM70, WV*
CU550 or WV-CU550A is used with this
model, select OFF for ALARM.
5. Move the cursor to DISPLAY MODE and press H]
to see the current setting. The masks that detect
the brightness changes start blinking.
6. To raise detection sensitivity, press CEl to return to
the MOTION DETECT menu.
7. To obtain the optimum detection level, move the
'T cursor to adjust the level.
8. Repeat the procedures above to obtain a satisfac­
tory setting.
9. Move the cursor to RET and press to return to
the CAM SET UP menu.
-36-