Panasonic WV-CPR650 - Manual (Page 31)

You can select internal sync mode (INT) or line-lock
mode (LL), Additionally, this model accepts the VBS
signal (color composite video or blackburst signal) and
VS signal (B/W composite video or composite sync sig­
nal). The VD2 signal (multiplexed vertical drive signal)
with the composite video output signal from external
equipment such as a Matrix Switcher is also aocept-
able.
Whenever the VD2 signal is supplied to this camera,
the camera automatically switches to the VD2 sync
mode.
1. Move the cursor to the SYNC parameter and
select rme-!ock(LL) or internat(lNT),
2. Press El.
If LL is selected, the SYNC menu appears, (If INT
is selected, the synchronization mode is automati­
cally set to internal sync oulse, and the menu is
not displayed.)
6. Synchronization Setting (SYNC)
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER —
AOC ON
SENS UP OFF
SYHC INT,
WHITE BAL ATM
MOTION DET OFF “1
LENS DRIVE DC
Important Notice:
1. The priority for the sync modes is as follows.
1. Multiplexed Vertical Drive (VD2) (Highest pri­
ority)
2. Line-lock (LL)
3. Color Composite Video or Blackburst Signal
(VBS)
4. B/W Composite Video or Composite Sync
Signal (VS)
5. Internal Sync (INT) (Lowest priority)
2. When the internal sync mode is to be used, select
INT. No gen-lock input signal should be supplied
to the Gen-lock Input Connector on the rear panel.
3. Whenever the multiplexed vertical drive pulse
(VD2) is supplied to the camera from an external
equipment such as a Matrix Switcher, the camera
sync mode is automatically switched to the VD2
mode.
4. When the VBS or VS gen-lock mode is to be used
select INT from this menu and supply the gen-lock
input signal to the Gen-lock Input Connector on
the rear panel.
5. The VBS gen-lock mode has its own menu for hori­
zontal and subcarrier phase adjustments. When
the cable length of the video output or the gen­
lock input is changed, the horizontal and subcarri­
er phase must be re-adjusted.
-29-