CANOGA PERKINS 9145 Network Interface Device - Manual (Page 71)

9145 Network Interface Device 3-51
To configure VLAN Priority Bit (P-Bit) follow these steps:
1. From the Main Menu type [ 3 ], "Port Information," and press . At the Port Information
Menu, type [ 2 ], "Port Configuration," and press . At the Port Configuration Menu,
type [ 3 ], "VLAN Configuration, and press .
2. At the VLAN Configuration Menu, type [ 3 ], "P-Bit Translation Tables," and press .
3. At the P-Bit Translation Tables, type the number for an incoming P-Bit and press ,
then type values for P-bits for outgoing packets, and then press to confirm.
4. To enable or disable the P-Bit Translation Table, type [ 9 ] and press . Pressing
cycles between Local User and Extension ports and the remote 9145’s ports (when
SBMC is enabled).
5. To return to the Main Menu, press .
Canoga Perkins Corp. Ethernet Network Interface Device 04-Dec-2006
Model 9145-5 V96.05 F96 9145 DC_172.16.142.225 07:02:17
-------------------------------P-BIT TRANSLATION TABLE--------------------------
Local Local Remote
User Port Ext Port Offline
1) Incoming P-Bit 0 translated to 0 0
2) Incoming P-Bit 1 translated to 1 1
3) Incoming P-Bit 2 translated to 2 2
4) Incoming P-Bit 3 translated to 3 3
5) Incoming P-Bit 4 translated to 4 4
6) Incoming P-Bit 5 translated to 5 5
7) Incoming P-Bit 6 translated to 6 6
8) Incoming P-Bit 7 translated to 7 7
9) P-Bit Translation Enabled? No No
Select [1-9]:
------------------------------------Messages------------------------------------