CANOGA PERKINS 9145 Network Interface Device - Manual (Page 66)

9145 Network Interface Device 3-46
2. At the Port Configuration Menu, type [ 2 ], "Functional Configuration," and press .
3. At the Functional Configuration Menu, type the number for an item and press .
Pressing cycles through the options. Press to highlight the select Local or
Remote columns. Press to select an option.
1. User Port Setting
Sets data rate and duplex option on the User Port. After typing [ 1 ] , pressing
cycles through the Data Speed and Duplex options. Options are Interface
Module dependant.
2. Ext Port Setting
Sets data rate and duplex option on the User Port. After typing [ 1 ] , pressing
cycles through the Data Speed and Duplex options. Options are Interface
Module dependant.
3. RMTF
Enables or Disables Remote Fault Forwarding (RMTF) when SBMC is enabled.
Enables or Disables Remote Fault Forwarding and Link Loss Echo (RMTF/LLE)
when SBMC disabled. Pressing cycles through the options. Options are
Disabled, Ext Port Enabled.
4. Link Loss Fwd
Enables or Disables Link Loss Forwarding (LLF). Pressing cycles through
the options. Options are Disabled, User – Ext, Ext – User, and Both Directions.
5. Flow Control
Enables or Disables flow control on the Remote port. Pressing cycles
through the options. Options are Disabled, Ext Port Enabled.
6. Maximum Frame Size: Sets maximum allowable Ethernet Frame size the 9145 will
forward. Size range is 1518-10000.
Canoga Perkins Corp. Ethernet Network Interface Device 04-Dec-2006
Model 9145-5 V96.05 F96 9145 DC_172.16.142.225 07:00:31
----------------------------------FUNCTIONAL CONFIGURATION----------------------
Local Remote
Offline
User Port Speed/Duplex 100M/Half
Ext Port Speed/Duplex 1000M/Full
1) User Port Setting Autonegotiate
2) Ext Port Setting Autonegotiate
3) RMTF Disabled
4) Link Loss Fwd Disabled
5) Flow Control Disabled
6) Maximum Frame Size 10000
7) Sideband Management Disabled
Select [1-7]:
------------------------------------Messages------------------------------------