CANOGA PERKINS 9145 Network Interface Device - Manual (Page 36)

9145 Network Interface Device 3-16
6. To retrieve the configuration file, type [get 9145.CFG] and press
7. To end the ftp session, type [bye] on the prompt and close the window.
You can use any text editor such as Notepad 1 or WordPad 2 to edit the configuration file. Please
see Appendix C for an example format and the different fields of a configuration file.
Once you have made your changes to the configuration file and are now ready to download the
changes to the 9145, follow these steps:
1. Open a command prompt on your PC and type [ftp xxx.xxx.xxx.xxx] where the x’s
are is the IP address corresponding to the 9145’s management IP address and press
.
2. Type the Username and Password and press
3. Set ftp to “binary” mode by typing [binary] at the prompt and press
1 2 Notepad and WordPad are trademarks of Microsoft Corporation