CANOGA PERKINS 9145 Network Interface Device - Manual (Page 13)

9145 Network Interface Device 2-1
Figure 5 – Bracket Attachment Detail
• Wall mounting: The 9145 has slotted holes on the bottom of the unit for wall
mounting. The 9145 requires 1” unobstructed space above and below the 9145
for ventilation. Canoga Perkins recommends a space of 5” on the right and 3” on
the left of 9145 bee left unobstructed to facilitate Interface Module Access, Cable
Access and Power Entry.
a. Install two #10 or #12 screws and anchors in the wall 9 3/8” apart, 1” from the
sides and 3/4” from the top of the desired location of the 9145. A template is
illustrated below. Leave the screws protruding from the wall 3/8” to 3/4”.
b. Hang the 9145 on the screws, matching the keyholes in the 9145 to the screws.