CANOGA PERKINS 9145 Network Interface Device - Manual (Page 50)

9145 Network Interface Device 3-30
4. At the prompt, select the Source, which is the inactive bank for the local module, then
select the Destination, which is the inactive bank for the remote module, and press
; the upgrade runs automatically.
To run the new software, swap banks, and reset the module. Follow these steps:
1. From the Main Menu, type [ 7 ], "Software Upgrade," and press .
2. At the Software Upgrade Menu, type [ 2 ], "Swap Bank & Reset," press to highlight
the Remote column, and press .
3. Type [ 2 ], "Swap Bank & Reset," check that the Local column is highlighted, and press
. Both modules reset and start using the new firmware.
Canoga Perkins Corp. Ethernet Network Interface Device 04-Dec-2006
Model 9145-5 V96.05 F96 9145 DC_172.16.142.225 07:38:04
------------------------------------SOFTWARE UPGRADE----------------------------
Time Since Last Restart 2 days 13:53:23
Local Remote Offline
Last Data
Active Firmware 96.05
Inactive Firmware 12.15
Bootcode 06.30
1) Software Reset Reset Reset
2) Swap Bank & Reset Swap Swap
3) Get New File with TFTP
Select [1-3]:
------------------------------------Messages------------------------------------
Swap