Storix Software SBAdmin Linux System Recovery Guide - Manual (Page 21)

Select “Yes” for Enable Remote Install Manager
Select the Configure button to the right to configure the settings. You will be presented with the following
window:
The Remote Install Username is set to “sbadmin” and may not be changed. Enter a password in the Remote
Install Password field. The password will be necessary to login to the remote install client.
Select the Network Adapter that should be configured to connect to the remote install client. If performing a
network boot, then you may select UseBootAdapter to use the adapter that was used to perform the network
boot. If you configured the Client Network Adapter on the previous screen, you can select UseInstallAdapter
to use the same adapter configured for network installation.
Enter the IP Address used to configure the network adapter. This field will be disabled if you selected to use
either the boot or install adapter, which will already be configured.
Enter the Subnet Mask used (if necessary) when configuring the network adapter. This field will be disabled if
you select to use either the boot or install adapter.
After pressing Done , the settings will be saved in the boot configuration. The adapter will be enabled, and a
remote connection (with appropriate password) will be accepted when booting from this media.
Configuring RIM after Booting from the Boot Media
From within the System Installation Menus select System Recovery Utilities . Then select Configure Remote
Install Manager , and follow the instructions for Configuring Remote Install Manager in the Utilities section.
Connecting to the Remote Install Process
To connect to the remote install client use one of the following:
Storix System Backup Administrator 21 Version 8.2 Linux System Recovery Guide