Manual-8 – Rane SR 3 User Manual
Page 8

Manual-8
When Update on Release is enabled, the SR updates its Page index when
the encoder is released, rather than updating each time the encoder is turned.
This feature allows users to scroll through and preview pages, select the Page
they want, then release the encoder to trigger the action (for example, recall
Preset on an RPM 88).
Knob Bump
When Auto Page is enabled and the encoder is pressed in and released (with-
out turning), the next Page is automatically loaded into the SR 3 display; the
Page index is updated after the Update Timer expires.
Note: Pages automatically roll from the last page to the first page while in
Bump mode.
The Update Timer determines how long the SR 3 waits before updating
its Page index once the encoder is released. Setting this value to 0 updates
the Page index instantly, with every press/release combination of the encoder.
Increasing this value allows users to scroll through and preview pages without
updating the Page index on every press.
The valid range for the timer is 0 to 5 seconds.
Min Backlight
Min Backlight
sets the desired brightness when the SR 3 is in its default or
resting state, after the backlight timer expires.
Max Backlight
Max Backlight
sets the desired brightness when the SR 3 is in its active state.
Backlight Timer
The Backlight Timer determines how long the LCD backlight remains on
after the last change was made. The timer is restarted whenever a change is
made to the push switch or encoder. The valid range for the timer is 1 to 25
seconds.
Max Num Pages
Max Num Pages
limits the number of user accessible pages. For example, if
Max Num Pages is set to 4, the user is only able to view Pages 1 through 4,
even though there are 12 other Pages (total of 16) stored on the device. The
SR 3 always displays Page 1 through Max Num Pages unless a value of 0 is
specified. If a value of 0 is specified the title page (Page 0) is displayed upon
power up and the user is unable to change pages.
Max Num Pages only applies when an Auto Page mode is enabled.