Weiser Powerbolt User Manual
Page 9
5. Programming Instructions
6. Proper Operation of Touchpad Electronic Deadbolt
7
To Enter Second Code
Push program button twice, then repeat steps
2-4.
5
Push the Lock button on outside touch pad to
extend latch bolt 1” which locks the door when
you leave.
Enter your desired personal code to retract
the latch bolt completely which unlocks the
door when you return home.
The T-turn on the inside of the door is used to
extend (lock) or retract (unlock) the latch bolt
when you are inside.
Using the key from the outside will also extend
(lock) or retract (unlock) the latch bolt.
This Touchpad Electronic Deadbolt should be
accompanied by a Weiser Knobset, Leverset,
or Handleset.
1
2
3
4
5
Enter your number to verify that it retracts
the latch B.
4
Snap access cover
I onto power board H.
Align cover to top of power board and press
down at the bottom of the cover (see illustra-
tion below). To coordinate with your home
decorating scheme, the access cover may
be painted to
match your
door.
CAUTION:
Prevent unauthorized
entry. This lock can be opened
using two different codes that are randomly
set at the factory. Upon installation and
set-up, replace both of these codes with
your own. Since anyone with access to the
power board can change these codes, you
must restrict access to the power board
and routinely check both codes to assure
they have not been altered without your
knowledge.