Weiser Powerbolt User Manual

Page 11

Troubleshooting Tips

If Electronics Are Not Working —

Check the Following:
Are your batteries good? Is the power strip

plugged in properly? (See step 4.6)
Are the batteries installed correctly and mak-

ing full contact? (See step 4.8) You should

hear a series of quick beeps when batteries

are installed correctly and making full contact.

Handing of Your Door
If the bolt does not extend when lock button is

pressed, check the handing of your door (See

Step 4.9)

Preset Factory Codes
This lock will maintain two different codes.

Two random codes are preset by the factory

for testing. It is recommended that you enter

Important Note:

Manual locking or unlocking the

deadbolt by turning the key or the T-

turn — the motion will be ﬁrm. This

resistance is normal for this lock.

two new security codes to cancel out the

preset codes. (See step 5).

Problems with Setting your Security Codes

— Check the Following:
You will hear a 2 second beep when your

codes are accepted. (See step 5.1-3).
If the unit does not beep — too much time has

elapsed between steps 1 & 2. Repeat these

steps faster.

Note: You have approximately 3 seconds

between step 1 & 2 for your codes to be

accepted. Please note the next statement.

Unauthorized Code Warning:
For your added security, a warning tone will

sound for 15 seconds if an incorrect security

code is entered three times consecutively. The

Touchpad will not operate for 1 minute.

Note: If several attempts were needed to

set your security codes — you may have

activated the warning sound. Wait 1 minute

for the unit to be operational again.

For assistance call

1-800-343-9652 USA

1-800-501-9471 CANADA

or visit www.powerbolt.com