Torbal AD50 Series Manual - Manual (Page 6)

Instruction Manual - TORBAL AD Series
CHAPTER 3.
COMMANDS AND ABBREVIATIONS
Command or Abbreviation Description
- - - - - - Taring or re-zeroing in progress
CAL The scale is in the calibration mode.
TARING The scale is taring before the calibration process.
LOAD XXX g Place a calibration weight on the pan to begin calibration.
C Calibration in progress
CAL FIN Calibration procedure is finished.
AW – X In animal weight this command represents the average weighing time.
CONT In parts counting, taring a container is required before continuing the counting transaction.
SAPL ON In parts counting or percent weighing this command indicates to place the sample on the pan.
SPL – XX In parts counting this command represents the current sample size setting.
FILL In parts counting, begin counting.
UNDER In check weighing this command represents the under limit and indicates under result.
OVER In check weighing this command represents the over limit and indicates an over result.
ACCEPT In check weighing this command indicates that the weighing result is within the limit range.
TARE In check weighing, tare before continuing.
SAMPLE In percent weighing this command indicates the weight of a stored reference weight.
READY
In percent weighing this command indicates that the scale is ready for percent weighing based
on a stored reference weight.
YES-NO
In totalizing this command indicates that a confirmation is required before the Totals are
cleared.
PRINT Printing in progress
COUNT FINISH TO START
COUNT PRESS C
In parts counting this command indicates that parts counting is finished.
6