Torbal AD50 Series Manual - Manual (Page 54)

Instruction Manual - TORBAL AD Series
To accept To change
7. To change the OVER limit follow the directions in Step 4 of this section and Table 8.C.4.
8. Once both limits have been set the scale will display a TARE command, indicating that the scale
must be tared. Before using the function place a container on the pan and press “T” to tare.
9. The scale is now ready to use. To perform check weighing place your object on the pan to check
whether the weight of the object falls within the designated range. If the weight is less than the
lower limit the scale will display the weight of the object and the command UNDER. If the weight
falls within the range, the ACCEPT command will be displayed. If the weight exceeds the upper
limit, the scale will display OVER.
54