Torbal AD50 Series Manual - Manual (Page 37)

Instruction Manual - TORBAL AD Series
7. To make a selection, press “T” (Yes) when the desired setting is displayed.
Note: When connecting the scale to a third-party software or third party printer, make sure that both the
host (scale) and the slave are configured with the same Baud and Parity settings.
7.1.6.2. Torbal Printer Configuration (RXP-4))
To connect the AD scale to a TORBAL (RXP-4) printer, use the following settings:
Scale settings (follow steps detailed in Section 9.1.1):
Baud Rate: 9600
Parity: None
Printer Settings (Follow the steps detailed in the RXP-4 Instruction Manual):
37