Torbal AD50 Series Manual - Manual (Page 52)

Instruction Manual - TORBAL AD Series
while command “ ---, COUNT FINISH, TO START COUNT PRESS C” is displayed, but before
pressing the “C” key. Once the “C” key is pressed the counting operation will reset.
To exit parts counting and switch to a different function, press “C” to clear the current function
and then press “F” to select a different function (follow Steps 1 through 3 from Chapter 8 on
page 44).
(C) Check Weighing
The check weighing function is used to compare a weight of an object against a preset target
range. To set the limits and use the check weighing function follow the steps below.
1. Upon entering the check weighing function, the UNDER limit is displayed. Command UNDER and
the under-limit weight setting are displayed sequentially. If this is the first time the function is used,
the setting will be 0.000g. Any new setting will be saved until changed or cleared through the
master RESET.
2. If an under limit has already been set and no change is necessary, press “T” (YES) to accept and
continue. If you wish to change the setting, press the 0(NO) key.
To accept To change
3. After pressing the 0 (NO) key a dash will appear on the display. A weight limit may then be
entered.
52