Torbal AD50 Series Manual - Manual (Page 49)

Instruction Manual - TORBAL AD Series
The sample size selection can range from 1 to 100 pieces. By applying short single presses to the
0 (NO) key the sample size will change in increments of one. By holding the 0 (NO) key
pressed, the sample size will change in increments of 5. To select a sample size of 99, press and hold the
0 key until the display reads 95, and apply four single presses until the sample size reads 99. Once
the desired sample size is displayed press the “T” (YES) key to accept and confirm the selection.
3. After confirming the sample size selection, the display will read SAPL On, indicating that you
may now place the sample on the pan (10 pieces if SPL-10 is selected).
4. Manually count out the sample and place it in the counting container located on the pan.
49