Torbal AD50 Series Manual - Manual (Page 19)

Instruction Manual - TORBAL AD Series
7.1.3.Mode configuration
TORBAL AD series scales can operate in seven application modes. A- Animal Weighing, B –
Parts Counting, C - Check Weighing, D – Display Hold, E-Percent Weighing, and F-Totalizing. Before
an application mode can be used, it must be enabled and configured. Once the application mode is
enabled it will be available for selection from the Function Menu.
By factory default the scale is in the weighing mode (WEIGH). To enable other application
modes, follow the steps below.
1. Enter the Main Menu by pressing the “M” key.
2. When MODE is displayed press the “T” (YES) key.
3. The application modes will now begin to display sequentially. Press the “T” key when the desired
application is displayed and follow the configuration steps for that mode.
Note: Scrolling through the options may be accelerated by pressing the 0 (NO) key.
19