Torbal AD50 Series Manual User Manual

Page 51

Instruction Manual - TORBAL AD Series

Note: If filling does not begin while the command FILL is displayed, after approximately 5 seconds the

scale will display 10pcs and will wait for the count to begin.

8. The display will now indicate the number of pieces placed in the container. Stop filling when

the desired count has been reached.

9. Once an accurate piece count has been taken, the container and its contents may be removed

from the scale. After the container with the counted pieces has been removed, the scale will

indicate the count is finished and that a new count may be initialized by pressing the “C” key.

The command “ ---, COUNT FINISH, TO START COUNT PRESS C will appear on the display

sequentially. To start a new count press the “C” key.

Note: If too many pieces have been placed into the container, remove the excess while the

container is still on the scale’s pan. You may also remove the container from the pan, remove

the extra pieces, and place it back on the pan to recheck the count. This may be performed