Rice Lake IQ Plus 355 Installation Manual V1.17 - Manual (Page 24)

20 IQ plus 355 Installation Manual
3.2.5 Program Menu
Figure 3-9. Program Menu
SERIAL Menu
Parameter Choices Description
Level 2 submenus
EDP BAUD
BITS
TERMIN
EOLDLY Specifies settings for baud rate, data bits, termination characters, and end-of-line delay used by
the EDP port.
PRINT BAUD
BITS
TERMIN
EOLDLY Specifies settings for baud rate, data bits, termination characters, and end-of-line delay used by
the printer port.
STREAM OFF
EDP
PRN Selects the serial port used for continuous transmission. See Section 7.3 on page 37 for
information about the IQ plus 355 continuous data format.
PRNDES EDP
PRN Print destination. Selects the port for data transmission when the PRINT key is pressed or the
KPRINT EDP command is sent.
Level 3 Submenus EDP Port and Printer Port
BAUD 9600
300
600
1200
2400
4800 Baud rate. Selects the transmission speed for the EDP or printer port.
BITS 8NONE
7EVEN
7ODD Selects number of data bits and parity of data transmitted from the EDP or printer port.
S BITS 1 BIT
2 BIT Selects the number of bits transmitted after each character.
TERMIN CR/LF
CR Termination character. Selects termination character for data sent from the EDP or printer port.
EOLDLY 0
number End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 0-255, in tenths of a second (10 = 1 second).
ECHO ON
OFF This command enables or disables echoing of the serial commands sent to the indicator.
Table 3-5. Serial Menu Parameters
9999999 9999999 9999999 9999999
18361.
(0 /5&1
0*.-
3&(6-"
OVNCFS
$0/4/6
%&-":
7&34 "-(065 %*(*/ 130(3. 1'03.5 4&3*"- $"-*#3 $0/'*( '03."5
OVNCFS
$0/456
$"/"%"
/0/&