Rice Lake IQ Plus 355 Installation Manual V1.17 - Manual (Page 23)

Configuration 19
3.2.3 Calibration Menu
See Section 4.0 on page 24 for calibration procedures.
Figure 3-7. Calibration Menu
3.2.4 Serial Menu
See Section 7.3 on page 37 for information about the IQ plus 355 serial data format.
Figure 3-8. Serial Menu
CALIBR Menu
Parameter Choices Description
Level 2 submenus
WZERO — Display and edit the zero calibration A/D count value.
DO NOT adjust this value after WSPAN has been set!
WVAL — Display and edit the test weight value.
WSPAN — Display and edit the span calibration A/D count value.
REZERO — Press Enter to remove an offset value from the zero and span calibrations.
Use this parameter only after WZERO and WSPAN have been set. See Section 4.1 on
page 24 for more information about using this parameter.
Table 3-4. Calibration Menu Parameters
9999999 9999999 9999999 9999999
8;&30
*CAL*
%JTQMBZBOEFEJU
[FSPDBMJCSBUJPO
"%DPVOUWBMVF
%JTQMBZBOEFEJU
UFTUXFJHIUWBMVF
87"-
*CAL*
%JTQMBZBOEFEJU
TQBODBMJCSBUJPO
"%DPVOUWBMVF
841"/
7&34 "-(065 %*(*/ 130(3. 1'03.5 4&3*"- $"-*#3 $0/'*( '03."5
CAL*
1SFTT&OUFSUP
SFNPWFPGGTFUGSPN
[FSPBOETQBO
DBMJCSBUJPOT
3&;&30
9999999 9999999 9999999 9999999
&0-%-:
OVNCFS
&%1 13*/5
13/
&%1
13/%&4
#*54 5&3.*/ #"6%
$3
0%%
&7&/
/0/& $3-'
4BNFBT&%1
&%1
0''
453&".
13/
7&34 "-(065 %*(*/ 130(3. 1'03.5 4&3*"- $"-*#3 $0/'*( '03."5
#*5
#*5
4#*54 &$)0
0/
0''