Rice Lake BCi Belt Scale - Installation & Operation Manual Version 2.00 - Manual (Page 66)

60 BCi Installation & Operation Manual
9.0 Appendix
BCi Data Sheet
0736 Rev. 5 6/10
Contact____________________________________________________Prepared By _________________________________
Company __________________________________________________Date ________________________________________
Address ___________________________________________________Notes of the Application ______________________
City ____________________________________________________________________________________________________
State/Zip ___________________________________________________Country _____________________________________
Email ______________________________________________________Phone ______________________________________
Fax ________________________________________________________
Page 1 of 2
CONVEYOR
INTEGRATOR REQUIREMENTS
MATERIAL
Belt Scale Questionnaire
Material being measured ____________________________________Bulk Density (lbs/cu. ft) _______________________
Corrosive state of material High Moderate Not Corrosive
(choose one)
(Supply sketch where possible) Sketch attached
Application: Inventory Load out Control Blending Legal for Trade
Material Feed Rate: _________________minimum t/hr Accuracy required: +/- __________________________%
_________________minimum t/hr
Constant Feed Rate: Yes No Automatic Tensioning Apparatus: Yes No
Access side: (looking in direction of belt travel) Left Right Both
Electrical classification at scale location: ______________________________________________ (Class Division Group if Applicable)
Profile: Horizontal Incline/decline ______ (degrees) Variable Incline _____ (degrees) Curved
Belt Speed: _________________minimum ft/min.
_________________minimum ft/min.
Belt length: ____________ feet Belt width: ___________ inches Conveyor length: ________ feet
Idler diameter: _________ inches Tail pulley dia: ________ inches Belt cleaning device Yes No
Trough angle: __________ degrees Idler spacing: ________ inches
(Indicate all that apply) Power available: _____________________________
Outputs required: Communications: Remote Display Totalizer: Panel Mount Wall Mount
4-20 mA AB Remote I/O Remote Display Rate: Panel Mount Wall Mount
RS-232 Device Net Load Out Control Explain details _______________________
Ethernet TCP/IP Profibus-DP _______________________________________________________________
Ethernet IP Printer Model _____________________________________