Rice Lake BCi Belt Scale - Installation & Operation Manual Version 2.00 - Manual (Page 57)

BCi Installation & Operation Manual - Calibration 51
Simulated Testing
A simulated load test consisting of at least three consecutive test runs should be conducted as soon as possible,
but not more than 12 hours after the completion of the material test, to establish the factor to relate the results of
the simulated load test to the results of the material tests. The results of the simulated load test should repeat
within 0.1 percent.
Simulated testing is used only with auto calibration of the integrator.
There are two different simulated load testing techniques that can be used. They are:
• Roller test chains
• Static test weights
There are several advantages and disadvantages to each of the list simulated testing techniques. They are listed
below.
Simulated Testing Type Advantages Disadvantages
Roller (chain) Simulates some conveyor belt
effects Chains do not provide a traceable
conveyor scale calibration standard.
Acceptable simulated test Heavy chains are difficult to handle.
Conveyor belt must be stopped to
apply and remove.
Linearity test requires several chains.
Chains are costly.
Static Simulates some conveyor belt
effects Weights do not provide a traceable
conveyor scale calibration standard
Easy to apply Does not simulate conveyor belt
effects
Conveyor belt does not have to be
stopped to apply
Linearity test is easy to perform
Detect load cell failures, and applies
force to the load cell
Acceptable simulated test
Table 5-2. Advantages and Disadvantages to Simulated Testing