Rice Lake BCi Belt Scale - Installation & Operation Manual Version 2.00 - Manual (Page 53)

BCi Installation & Operation Manual - Calibration 47
to enter the number of belt revolutions.
Figure 5-2. Enter Number of Revolutions
6. The operator will key in the number of times the belt traveled past the reference point.
7. The integrator will then calculate the pulses per unit of measure. This will be used for displaying the
speed of the belt and totalizing the weight during operation.
8. The number of belt revolutions is stored as the test duration. This value is used for auto calibration when
the integrator is being calibrated to the load cell.
5.2 Integrator Calibration
There are three modes of integrator calibration:
• Auto Cal
• Material Cal
• Zero Cal
All three calibration methods are described in the following sections and are their softkey locations.
Figure 5-3. Calibration Method Softkeys
End
SCALE #1
Home
11/23/2011 08:13AM
96489 Pulse
261 Per Sec
889.25 Time Running
Cancel
Enter Number of Revolutions
=> 1.0
11/23/2011 08:13AM
Exit=>
Test Time
Test Accumulator
Old Span Error %
Auto Cal
Span Error %
13.50
117.4
3574
25.00
Progress
Material Zero Cal