Rice Lake BCi Belt Scale - Installation & Operation Manual Version 2.00 - Manual (Page 35)

BCi Installation & Operation Manual - Integrator Hardware Setup 29
Reconnect power to the integrator.
Figure 3-4. Backplate Torque
The integrator automatically recognizes all installed option cards when the unit is powered on. No
hardware-specific configuration is required to identify the newly-installed card to the system.
Figure 3-5. Pulse Input Board Option Card
Serial Communications
The four communications ports on the BCi CPU board support full duplex RS-232, 20 mA output, or RS-485
communications at up to 115200 bps.
To attach serial communications cables, route the cable through the cord grip and ground the shield wire as
described on page 26. Remove the serial connector from the CPU board and wire to the connector. Once cables
are attached, plug the connector into the header on the board. Use cable ties to secure serial cables to the inside of
the enclosure.
5PSRVFCBDLQMBUFTDSFXT
UPJOMC /N
7
+
(/%
16-4&*/
7
(/%
16-4&*/