Rice Lake Intrinsically Safe - Manual (Page 47)

320IS Installation Manual - EDP Commands 41
5.1.5 Normal Mode Commands
The serial transmit weight data commands (see Table 5-13) transmit data to the EDP port on demand. The SX and
EX commands are valid only in normal operating mode; all other commands are valid in either setup or normal
mode.




Command Description Values
AO2.SOURCE Analog output source GROSS, NET
AO2.OFFSET Zero offset 0%, 20%
AO2.ERRACT Error action FULLSC, HOLD, ZEROSC
AO2.MIN Minimum value tracked 0–999 990
AO2.MAX Maximum value tracked 0–999 990
AO2.TWZERO Zero calibration 0–65535
AO2.TWSPAN Span calibration 0–65535
Table 5-12. ALGOUT 2 EDP Commands
Command Description Response Format
SX Start EDP streaming OK or ??
EX Stop EDP streaming OK or ??
RS Reset system —
XG Transmit gross weight in displayed units nnnnnn UU
where nnnnnn is the weight value, UU is the units. XN Transmit net weight in displayed units
XT Transmit tare weight in displayed units
XG2 Transmit gross weight in non-displayed units
XN2 Transmit net weight in non-displayed units
XT2 Transmit tare weight in non-displayed units
XE Query system error conditions xxxxx yyyyy
See Section 7.1.2 on page 46 for detailed information about
the XE command response format.
XA Transmit accumulation value
UID set unit ID nnnnnn
CONSNUM Set consecutive number
Table 5-13. Normal Mode EDP Commands