Rice Lake Intrinsically Safe - Manual (Page 43)

320IS Installation Manual - EDP Commands 37
Command Function
KZERO In weighing mode, press the ZERO key
KGROSSNET In weighing mode, press the GROSS/
NET key
KTARE Press the TARE key
KUNITS In weighing mode, press the UNITS key
KPRINT In weighing mode, press the PRINT key
KLEFTARROW In setup mode, move left in the menu
KRIGHTARROW In setup mode, move right in the menu
KUPARROW In setup mode, move up in the menu
KDOWNARROW In setup mode, move down in the menu
K0-K9 Enters the number in the entry buffer,
used for keyed tare entry.
KDOT Press the decimal point (.)
KENTER Press the ENTER key
KEXIT Exit setup
KSAVE Saves configuration without exit
KTIMEDATE *Display time and date
KTIME *Display time
(pseudo key)
KDATE *Display date
(pseudo key)
KDISPACCUM Press ACCUM key
KCLRACCUM Clears accumulated register
KDISPTARE Display tare
(pseudo key)
KID Display unit ID entry screen
KCOUNT Go to piece count mode

(pseudo key)
KCLR Press the clear key
* I/O module required
Table 5-1. EDP Key Press Commands