Rice Lake 120 Plus Digital Weight Indicator - Manual (Page 33)

Test Mode Operations 29
4.0 Test Mode Operations
Use this mode to test the parameters of the weight indicator.
This procedure should only be performed by a certified technician.
To enter test mode, press the “ setup switch ” for three seconds. The display will change from CONFIG to A/DTST .
Figure 4-1. Test Mode Operation Menu
Parameter Description
A/D TEST Displays A/D Test. Press the ENTER key to display the raw count value from A/D converter.
TEST LCD Light on all LCD segments for test LCD.
I/O Display digital input (Remote Switch) and output (Set Point) status.
BATTERY
VOLTAGE Display battery voltage in V.
BATTER
CURRENT Display battery charging current in A.
FILTER 3 Displays filtered raw count for digital filter 3.
DEFAULT Default parameters. Press the ENTER key to reset configuration and calibration parameters to
factory default values.
NOTE: Not available in panel mode operation
TRANSMIT U Transmits "U". Press the ENTER key to send the U character [ASCII: 85 decimal, 55 hex] to test
the serial line quality and integrity.
Table 4-1. Test Mode Option Parameters
Note
T N E R R U C Y R E T T A B E G A T L O V Y R E T T A B T S E T D / A
uuuuuu READY
DEFAULT TRANSMIT U ECHO R
TEST LCD IO
FEC600
FILTER3
0 0 0 0 0
OUT2
OUT1 RSW3
RSW2
RSW1