Rice Lake 120 Plus Digital Weight Indicator - Manual (Page 27)

Configuration 23
Hold Function TOGGLE
DISABL
AVERAG
AUTO Hold function.
TOGGLE: After pressing the HOLD key the weight will be frozen if no motion and bigger
than zero. Press HOLD again, to go back to weighing mode.
AVERAG: After pressing the HOLD key if bigger than zero and not increase weight, then
start to take the average value in 3 seconds, the average weight will be frozen. Press
HOLD again or after 2 minutes, to go back to weighing mode.
AUTO: when there is no motion and bigger than zero, the weight will be frozen. Press
HOLD again or after 2 minutes, to go back to weighing mode.
Average Timer 4SEC
2SEC
3SEC
5SEC
6SEC
8SEC
12SEC
14SEC
16SEC Timer for hold function to average raw data or time limited according to the HOLDMD
setting.
See Hold function section for details.
Hold Timer 2MIN
1MIN
3MIN
4MIN
5MIN
6MIN
8MIN
10MIN Timer for hold function to limit the time of freeze. See Hold function section for details.
Key Lockout NONE
UNIT
PRN
HOLD
GROSS
ZOTA
UNPR
GRUNPR
ALL Front Panel Key Lockout option. In some applications, it is desirable that the front panel
keys cannot be accessed while operating in normal mode.
NONE: none of the keys are locked.
UNIT: UNITS key disabled.
PRN: Print/Enter key disabled.
HOLD: HOLD key disabled.
GROSS: GROSS/NET key disabled.
ZOTA: ZERO, TARE, and PRESET TARE keys disabled.
UNPR: UNITS and Print/Enter keys disabled.
GRUNPR: GROSS/NET, UNITS and Print/Enter keys disabled.
ALL: disable all keys.
Note that this option only disables the front panel keys and does not lock out the
functions that these keys perform. The zero, gross/net, tare, and print command are still
accessible from the remote inputs on HDB15 of the 120 Plus.
Consecutive
Numbering 1
number Consecutive Numbering allows sequential numbering for print operations. This value is
increased following each print operation.
Gravity Adjust Off
On Sets the latitude and elevation parameters for the geographic location where the
calibration takes place. It compensates for the varience in gravitational pull from one
location to another.
Parameter Options Description
Table 3-6. Program Menu