beautypg.com

Maintenance and care, Engine compartment – Mercedes-Benz SL-Class 2013 Owners Manual User Manual

Page 517

background image

Example

X

Park the vehicle on a level surface.
Only check the coolant level when the

vehicle is on a level surface and the engine

has cooled down.

X

Turn the SmartKey to position 2 in the

ignition lock (

Y

page 155).

On vehicles with KEYLESS-GO, press the

Start/Stop button twice (

Y

page 155).

X

Check the coolant temperature gauge in

the multifunction display.

The coolant temperature must be below

158 ‡ (70 †).

X

Turn the SmartKey to position

0 (

Y

page 155) in the ignition lock.

X

Slowly turn cap ; half a turn counter-

clockwise to allow excess pressure to

escape.

X

Turn cap ; further counter-clockwise and

remove it.

If the coolant is at the level of marker bar

= in the filler neck when cold, there is

enough coolant in coolant expansion

tank :.
If the coolant level is approximately 0.6 in

(1.5 cm) above marker bar = in the fuel

filler neck when warm, there is enough

coolant in expansion tank :.

X

If necessary, add coolant that has been

tested and approved by Mercedes-Benz.

X

Replace cap ; and turn it clockwise as far

as it will go.

For further information on coolant, see

(

Y

page 582).

Windshield washer system and

headlamp cleaning system

G

WARNING

If antifreeze comes into contact with hot

components in the engine compartment, it

may ignite. There is a risk of fire and injury.
Let the engine cool down before you add

antifreeze. Make sure that antifreeze is not

spilled next to the filler neck. Thoroughly

clean the antifreeze from components before

starting the engine.

G

WARNING

Windshield washer concentrate is highly

flammable. If it comes into contact with hot

engine components or the exhaust system it

could ignite. There is a risk of fire and injury.
Make sure that no windshield washer

concentrate is spilled next to the filler neck.

Example

X

To open: pull cap : upwards by the tab.

X

Add the premixed washer fluid.

X

To close: press cap : onto the filler neck

until it engages.

The washer fluid reservoir is used for both the

windshield washer system and the headlamp

cleaning system.
For further information on the windshield

washer system and headlamp cleaning

system, see (

Y

page 583).

Engine compartment

515

Maintenance

and

care

Z