Mercedes-Benz SL-Class 2014 Owners Manual - Manual (Page 375)

may not be displayed on the map, even if
the symbol display is switched on.
X To exit the menu: press the k back
button.
Selecting map information
Map information in the display
During route guidance, you can have map
information shown at the bottom edge of the
display.
X To show the menu: press W the COMAND
controller.
X Select Navi Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X Select Map Settings Map Settings and press W to
confirm.
The map settings menu appears.
X Select Text Information On Map Text Information On Map and
press W to confirm.
A # dot indicates the current setting.
X Select Current Street Current Street , Geo- Geo-
coordinates coordinates or None None and press W to
confirm.
X To exit the menu: slide XVY the COMAND
controller.
Road display
:
Road names or numbers, e.g. for
highways
Geo-coordinate display
:
Current height above average sea level
(rounded to the nearest 10 m)
; Current vehicle position: latitude
coordinates
= Current vehicle position: longitude
coordinates
? Number of GPS satellites currently being
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
display : may vary from the actual value,
because the navigation system uses the GPS
signals for the calculation.
During the "Move map" function, you will see
the geo-coordinates of the crosshair position.
Height display : and number of satellites
used ? are not displayed.
Display switched off
:
Current map orientation
While moving the map, you will see additional
data, depending on the crosshair position, if
the digital map supports this data. A street
name, for example, can be shown here
(
Y
page 370).
Coordinates on the map
X To show the menu: press W the COMAND
controller.
Navigation
373
COMAND
Z