Mercedes-Benz SL-Class 2014 Owners Manual - Manual (Page 346)

You can select the icons that you want
COMAND to display.
If no points of interest are available, you will
see a message to this effect.
i You also see this message if you have
selected the No No Symbols Symbols menu item under
"Map display" (
Y
page 372).
X To confirm the message: press W the
COMAND controller.
X To select a POI: select Next Next or Previous Previous
and press W to confirm.
X To show details for the selection: select
Details Details and press W to confirm.
X To change to the map: slide ZV the
COMAND controller.
You can move the map and select the map
section.
X To start route calculation: select Start Start
and press W to confirm.
A prompt appears asking whether the point
of interest should be used as the
destination.
X Select Yes Yes or No No and press W to confirm.
i Cont. Cont. is displayed instead of Start Start when
Calculate Alternative Routes Calculate Alternative Routes is
activated in the navigation menu
(
Y
page 354).
Personal POIs
General notes
i The use of personal POIs for displaying
traffic surveillance equipment is not
permitted in every country. Please observe
the country-specific regulations and adapt
your speed accordingly when driving.
Settings
Calling up the "Personal POIs" menu
"Personal POIs" menu
X To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X Select Navi Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X Select Personal POIs Personal POIs and press W to
confirm.
Displaying personal POIs on the map
The personal POIs are shown on the map with
an icon according to their category.
X Call up the "Personal POIs" menu
(
Y
page 344).
X Select Display Personal POIs On Map Display Personal POIs On Map
in the menu and press W to confirm.
You can select different categories.
344
Navigation
COMAND