Losi LOSB9607 - Manual (Page 4)

Lithium Charge Converter Page 4 of 6
Safety Precautions:
- Read all safety precautions prior to each use
- Do not use this Lithium Charge Converter with any charger other than one
documented in the Restrictions / Limitations section above or damage and
possibly fire will result.
- Do not attempt to charge any battery pack not documented in the Restrictions
/ Limitations section above; doing so can result in overheating, damage or fire.
- Before start of charge, it is the sole responsibility of the user to ensure the
estimated number of cells is actually the same as the battery you are about to
charge. If the estimated count is not correct, follow the instructions to adjust
to the correct count prior to beginning of charge.
- Read all safety precautions provided with the battery to be charged prior to
using the Lithium Charge Converter
- Before charging, check battery type for LiPo or M1, and re-verify the number
of cells in the battery to be charged
- Keep away from moisture, rain, direct sunshine, dropping or vibration
- Keep away from flammable objects
- Do not connect directly to a power supply
- Do not use if input power is over 8A; doing so will result in overheating,
damage or fire.
- Do not discharge any battery through the Lithium Charge Converter even if
the approved charger supports discharging. This will over-discharge the
LiPo/M1 battery and cause permanent damage or fire.
- Do not charge NiCd / NiMH / or lead acid batteries
- Do not attempt to charge dead or damaged batteries
- Ensure proper polarity for connection to charger
- Ensure proper polarity at battery connection
- Do not attempt to charge any single-cell batteries; doing so will result in
overheating, damage or fire.